Programming device-meter AR911
- this device is used to set and measure standard current and voltage signals
- analogue output/input (programming device or meter):
- current 0/4÷20mA (active output, cannot be supplied in two-wire current loop)
- current 4÷20mA (passive) for 2-wire current loop
- voltage 0/2÷10V
- output allows user to control or test devices with voltage or current input (proportional valves, actuators, inverters, motors, transducers, etc.).
- soft start/stop (ramping) or a triangular wave generator triggered and stopped manually
- programmable configuration parameters (display range, range and step changes of output signal, soft start/stop, auto-off time of the device, zero calibration, and amplification of the measured or setpoint signal, etc.)
- quick and easy to readout:
- of the actual value of the measured or output signal (mA, V or converted into a programmable display range)
- type of signal set
- operational direction
- diagnostic functions facilitating fault detection of the tested system, e.g. a short-circuit in voltage signal system, open circuit loop
- option of protecting access to the configuration of parameters with password
- ergonomic hand-held design with rubberised side handles
- simple and reliable banana connectors for laboratory use
- highly visible LCD display (without backlighting) and functional keyboard
- power supply from two AA batteries (R6)
- auto shut-off of the calibrator after a specified time of inactivity
- a built-in battery charging system (charger included)
- auto power off when battery charge level is too low
- high resistance to interference occurring in industrial environments
- ingress protection rating: IP43
- dimensions: 162 x 89 x 25 mm
- weight: 230 g (with batteries)
- operating temperature range: 0 ÷ 50°C
- relative humidity range: 0 ÷ 90 % (no condensation)
Availability: In stock
